Upgrades

3D printers | Kossel | Upgrades

Anycubic Kossel BMG Upgrade

This Anycubic Kossel BMG Upgrade guide will help you to install BMG extruder. This is a dual extruder that really helps with underextrusion problems. It comes with a smaller motor (optional), because it is geared 3:1 instead of 1:1.  Step 1: Order a BMG Dual Driver Extruder If you want to save up a few…

Kossel | Upgrades

Anycubic Kossel Volcano Upgrade

This is a complete guide for an Anycubic Kossel Volcano Upgrade.You can print this upgraded effector with ABS/ASA and install new parts in about 1-2 hours.Support Robert Schmiedt who designed this awesome effector. This effector uses original leveling probe, so auto leveling will still work.5015 fan with dual cooling duct solves problems with cooling and…

Kossel | Upgrades

Anycubic Kossel E3D V6 Upgrade

This is the best E3D V6 upgrade for Anycubic Kossel you can find on the internet. The printed effector is much lighter than the original one which helps with ghosting and other problems. This effector also uses original leveling probe, so auto leveling will still work. 5015 fan with dual cooling duct solves problems with…

3D printers | Calibration | Kossel | Upgrades

Anycubic Z probe accuracy

Anycubic Z probe accuracy test. I could not find any informations about accuracy of this original probe which was being sold with Anycubic Kossel Linear Plus so I used Klipper and PROBE_ACCURACY to measure it. WHERE TO BUY 1. Accuracy testing with multiple attaching and removing This routine was tested because we need to attach…

Kossel | Marlin | Upgrades

Anycubic Kossel SKR 1.3 upgrade

Kossel SKR 1.3 TMC UART is one of the best upgrades you can do.Before ordering anything decide if you want to change your board and use Marlin or you want to try Klipper and keep the original Trigorilla board. SKR provides much higher computing power which is so needed for fast printing with our delta…

Kossel | Upgrades

Anycubic Kossel Hot End Silicone Sock

Hot end silicone sock is on of the best and cheapest upgrades you can do to your 3D printer.This article applies to all 3D printers with a V5 J-Head, such as Kossel Pulley, Kossel Linear Plus, i3 Mega and so on… As you can see in the picture below, the cooling fan affects nozzle (hot…

Kossel | Upgrades

Anycubic Kossel Replacement Parts

After seeing many posts on Facebook suport groups asking for replacement parts, I decided to write down my recommendations. Most of the reccomended parts are from Triangle lab which sells top quality products and are tested by thousands of people. Spring steel PEI flexplate This is a better alternative to Ultrabase. Even 100k$ Stratasys 3D…

Kossel | Upgrades

Anycubic Kossel Bed Upgrade

Original heated bed with a sticker Anycubic Kossel Linear Plus comes with a 240 mm round heated bed and a 230 mm printable area. Why only 230 mm?For safety and because the bed is usually not straight at the edges. I have decided to add only Ultrabase nad PEI Flexplate upgrades in this guide, because…