Anycubic Kossel Klipper extruder PID calibration
Calibration | Klipper | Kossel
1. Check extruder name
2. Move effector close to the bed
3. Open OctoPrint in your browser
4. Send a PID calibration command
5. Troubleshooting
5.1. Order hot end silicone sock
Anycubic Kossel Hot End Silicone Sock
28. 4. 2020
No Comments
Hot end silicone sock is on of the best and cheapest upgrades you can do to your 3D printer.This article applies to all 3D printers with a V5 J-Head, such as Kossel Pulley, Kossel Linear Plus, i3 Mega and so on… As you can see in the picture below, the cooling fan affects nozzle (hot end) temperature. On the left
5.2. Check thermistor
5.3. Try PID calibration with a lower temperature
5.4. Repeat PID calibration with desired temperature
