After a successful Mega i3, Anycubic announced Mega S printer which is an upgraded standard Mega i3 with a Titan extruder.
This extruder allows printing flexible materials such as TPU
FDM printing technology
Build area of 210 x 210 x 205 mm
Print materials: PLA, PETG, TPU, Wooden, CPE
Max extruder tepmerature: 260°C
Max bed tepmerature: 110°C
Motherboard: Trigorilla 8-bit
Drivers: A4988, 16 microsteps/step
Position Accuracy: X,Y 0.0125mm Z 0.002mm
Layer height: 0.05-0.3 mm
Preassembled 3D printer
Plier
Scraper
Tool set
Card reader
SD card
User manual
Power cord
USB cable
Screws
Spare V5 hot end and end stop
This printer comes with a heated bed with max temperature of 110°C and awesome Ultrabase surface.
Ultrabase works very well with most of the filaments.
The best thing about it is the surface. It is coated with a structure which helps with adhesion and after it cools down, the printed model comes easily off even without using the spatula
Anycubic i3 Mega PID calibration is a crucial step to keep the hot end temperature at desired level. Without it, you woul get thermal runaway error, or your printed model would have artifacs from changing temperature while printing. How does…
Anycubic Z probe accuracy test. I could not find any informations about accuracy of this original probe which was being sold with Anycubic Kossel Linear Plus so I used Klipper and PROBE_ACCURACY to measure it. WHERE TO BUY 1. Accuracy…
Correct bed leveling is a crucial step to start printing. Without proper leveling you can damage your bed surface and nozzle or you will start printing in the air. This method is called “paper method”. Home your printer Click on…
V5 hot end silicone sock is one of the best cheap upgrades you can do.It insulates the hot end and nozzle from cool air coming from cooling duct and also protects the hot end from any melted plastic. 1. Why…
This Anycubic Kossel BMG Upgrade guide will help you to install BMG extruder. This is a dual extruder that really helps with underextrusion problems. It comes with a smaller motor (optional), because it is geared 3:1 instead of 1:1. Step…
What is a combing mode? Combing is a Cura’s feature that recalculates nozzle travel to eliminate any surface artifacts such as blobbing. The difference between combing off and combing all is clearly visible in the picture below. 1. Combing Mode…