Anycubic Kossel Marlin flow calibration

After extruder calibration you should calibrate material flow.
It is possible that without flow calibration you printer will be over extruding and your print quality will be bad.
You can easily modify it in your slicer, such as Cura.

1. Download cube stl file

Click on the picture and download a 25*25*25 mm cube.

2. Slice it with a vase mode on

Open the cube in your slicer program, I use Cura as you can see from the screenshot.
Turn on the vase mode – Spiralize Outer Contour in Cura.

3. Print it

Make sure that your first layer is well calibrated and print the cube.

4. Measure wall thickness

Use as precise tool as you can and measure wall thickness at different places on all sides.
Calculate average value, in my case 0.5 mm.

5. Check your line width

Open your slicer and look for a Line Width value. If you have a 0.4 mm nozzle, this value should also be 0.4 mm.

6. Look for a material flow settings

Find your material flow settings, you will need that number later.

6. Calculate new flow settings

For example:
Your average wall thickness value is 0.5 mm
But it should be 0.4 mm
Your material flow is 100%

New material flow = flow * (wall width / measured value)

A little bit of math:
New Flow = 100 * (0.4 / 0.5) = cca 80%

7. Modify and save new flow value

Locate Flow settings in your slicer and insert new value.
I always add at least 5% more for the initial layer.

8. Print a whole cube

You should always test your new settings.
Print the whole cube or another calibration model and verify results.
It is possible that your measurements were not so precise and you will need some more tuning

From my experience I have always calculated flow value which was cca 5% smaller – you can see that from gapes between lines.

So in my case, my ideal value for PLA is cca 85% flow for the initial and top/botoom layer and 90% for the rest of them.

Be the first to comment

Leave a Reply

Your email address will not be published.


*