Month: August 2019

Kossel | Upgrades

Anycubic Kossel fan upgrade

Why should I do that? I have been tired of the noise. After hundrends of printing hours Kossel became very noisy a I couldn’t sleep at the same room so I have choosed new fans with sufficient air flow [CFM] and low noise [dB] and started working on this article. Power supply fan It was…

Kossel | Upgrades

Anycubic Kossel extruder mount

Introduction The goal was to create an adjustible extruder mount Original mount tends to break brittle filaments Extruder mount in the pictures is var4, I recommend printing newer version – var5 version. ExtruderHolder-var5: Angle annotation 40 min print time 9 g of PLA filament you will need longer M4 bolt (plus 4 – 6mm), M4…

Kossel | Upgrades

Anycubic Kossel fans disassembly

Tired of loudy fans on your printer, do you want a better cooling?Continue reading… Power supply fan Charasteristics:Voltage: 18VCurrent: 0.12A Kossel PSU fan disassembly 1) Loose two screws holding the power supply on Kossel.2) Loose two screws holding black plastic part of PSU3) Remove the plastic part by pulling it out4) Loose screws under that…

Flower pot

Ikea Skadis flower pot

Thinking about Skadis storage system improvements?Try this flower pot upgrade. 3D modeling The first step was to create a precise 3D model in Autodesk Inventor. Water drainage and air flow While modeling flower pot I have focused on gaps between Skadis container and the flower pot for air flow, which are about 1 mm wide.You…